Плата управления SPIDER от FYSETC для Voron 3d

600 000 so'm
Доступно: дополнительная информация


  • https://github.com/FYSETC/FYSETC-SPIDER


    • Compact size: 155.3mm x 76.5mm
    • Based on STM32F446 180Mhz,all IOs can withstand 5V voltage
    • 8 TMC stepper drivers support, with Uart&SPI support
    • Improved TMC jumper settings again,simpler and easier
    • 28V input max,12V@5A DC-DC,5V@8A DC-DC (Especially for Raspberry Pi)3.3V@0.8A LDO
    • Two car fuses for hot bed input and main power input
    • Limit switch socket 24V/5V/3.3V optional, ready for more other equipment, such as -inductive sensor, BL-Touch
    • XH2.54 connectors
    • 10x PWM capable power mosfet outputs (1 for HotBed, 3 for Heat-End, 3 for fans, 3 for RGB LED strip)
    • 3pin temperature header, you can use thermistor or thermocouple (requires AD597 module)
    • Up to 8 ways PWM fans (only use 1 extrueder and no 12V/24V RGB used ),2 ways RGB led(12V & 24V optional) ,1 way 5V-RGB led (NEO-PIXEL/WS2812)
    • RepRapDiscount SmartController compatible pin header on board
    • UART1-Raspberry Pi pin header (including 5V@8A power supply)
    • 2X4 PinHeader Out for SD Card moudle
    • Onboard micro-SD card
    • Type-C and Type-B USB connector optional
    • EXP1 & EXP2 have more multiplexing functions, such as USART, I2C, CAN
    • SD card & USB upload support
    • A 4.7kOhm 0.1% temperature sensor pull up resistor is used, PT1000 can be connected directly. For PT100, an amplifier board must be used.


For This Quantity